11.2.2 Modem setup procedure
Analog modems obviously do not require any setup. The only case in which setup could be necessary
is if the modem has been bought in a country with a telephony system different than the target country
where the modem will be used.
GSM modems need to be set up prior to using them with the controller. Use the gm_setup program
(installed together with LiteEdit) to perform initial setup of the modem. See the latest Inteli
Communication Guide (available on the
SIM card is inserted.
N
:
OTE
It is always recommended to use modems bought in and approved for the target country.
11.3 Internet connection
A PC can be connected to the controller also remotely via Ethernet (internet, intranet). An appropriate
Ethernet communication module must be used.
11.3.1 SPtM
Use a plug-in communication module
via the internet. The setpoint
IB-Lite
Static IP
IB-Lite
Static (Public) IP
IL-NT GPRS
Static (Public) IP
IB-Lite
Non-static non-public IP
Only AirGate ID
(controller nickname)
IL-NT GPRS
Non-static non-public IP
Only AirGate ID
(controller nickname)
I
NTERNET CONNECTION FOR SINGLE CONTROLLER
NT
InteliCompact
, SW version 2.1
InteliCompact-NT-2.1-Reference Guide.pdf, ©ComAp – May 2015
ComAp web
site) for details. The setup must be done while a
IB-Lite
or
IL-NT-GPRS
COM1 Mode
must be set to the DIRECT position.
Ethernet
CROSS-WIRED
RJ45
ETHERNET CABLE
Ethernet
RJ45
LAN / WAN /
INTERNET
LAN / WAN /
INTERNET
BTS / Mobile
provider
Ethernet
RJ45
LAN / WAN /
INTERNET
BTS / Mobile
provider
to connect to the IC-NT SPtM controller
Ethernet
RJ45
Ethernet
RJ45
Ethernet
RJ45
Ethernet
RJ45
LAN / WAN /
INTERNET
Ethernet
RJ45
143
Need help?
Do you have a question about the InteliCompact NT and is the answer not in the manual?