ComAp InteliCompact NT Reference Manual page 170

Setpoint: CAN Bus Mode
Group Comms Settings
Range [units] 32C, 8C [-]
Related MINT
applications
Description CAN bus speed selection.


N :
OTE
Use low speed for a long-distance connection only. Set all connected
controllers to the same speed.
Setpoint: IBLite IP Addr
Group Comms Settings
Range [units] [-]
Related All
applications
Description If DHCP is DISABLED this setpoint is used to adjust the IP address of the
Ethernet interface of the controller. Ask your IT specialist for help with this
setting.
If DHCP is ENABLED this setpoint is used to display the IP address, which
has been assigned by the DHCP server.
Setpoint: IBLite NetMask
Group Comms Settings
Range [units] [-]
Related All
applications
Description If DHCP is DISABLED this setpoint is used to adjust the IP address of the
Ethernet interface of the controller. Ask your IT specialist for help with this
setting.
If DHCP is ENABLED this setpoint is used to display the IP address, which
has been assigned by the DHCP server.
Setpoint: IBLite GateIP
Group Comms Settings
Range [units] [-]
Related All
applications
Description If DHCP is DISABLED this setpoint is used to adjust the IP address of the
gateway of the network segment where the controller is connected.
NT
InteliCompact , SW version 2.1
InteliCompact-NT-2.1-Reference Guide.pdf, ©ComAp – May 2015
32C: High speed CAN (250 kbps) applicable for up to 32 controllers,
CAN bus length limited to 200 meters.
8C: Low speed CAN (50 kbps) applicable for up to 8 controllers,
CAN bus length limited to 900 meters.
170