ComAp InteliCompact NT Reference Manual page 237

Related All
applications
Description This is the actual PWM percentage on the
Value: GSM SignalLvl
Group Controller I/O
Units %
Related All
applications
Description IL-NT-GPRS
value helping to find the best signal and for troubleshooting cases.
Value: GSM ErrorRate
Group Controller I/O
Units -
Related All
applications
Description IL-NT-GPRS
quality. The lower value, the higher the signal quality.
Value: GSM Diag Code
Group Controller I/O
Units -
Related All
applications
Description Diagnostic code for the
support this value as well. Helps in troubleshooting.
T
ABLE OF
Code
0
1
2
3
4
5
6
7
8
9
10
11
12
13
NT
InteliCompact , SW version 2.1
InteliCompact-NT-2.1-Reference Guide.pdf, ©ComAp – May 2015
module shows the strength of the GSM signal. It is a relative
module shows this information for relative evaluation of signal
IL-NT-GPRS
D C
IAGNOSTIC ODES
Description
OK. No error.
Not possible to hang up.
IL-NT-base is switched off
IL-NT-GPRS is switched on
IL-NT-GPRS – error in initialization
IL-NT-GPRS – not possible to set the APN
IL-NT-GPRS – not possible to connect to GPRS network
IL-NT-GPRS – not possible to retrieve IP address
IL-NT-GPRS – not accepted DNS IP address
Error in modem detection
Error in initialization of analog modem
SIM card is locked (Possibly PIN code required, PIN needs to be deactivated) or
unknown status of SIM locking
No GSM signal
Not possible to read the SIM card parameters
AVRi output of the controller.
modem. Standard GSM modems usually
237