Group: Comms Settings - ComAp InteliCompact NT Reference Manual

Setpoint: Reset To MAN
Group Basic Settings
Range [units] DISABLED, ENABLED [-]
Related All
applications
Description If this function is enabled, the controller will switch automatically to MAN
mode when there is a red alarm in the alarm list and fault reset is pressed.
This is a safety function that prevents the gen-set starting again
automatically if the gen-set is stopped due to a red alarm, the alarm is no
longer active and fault reset is pressed.
Setpoint: Backlight time
Group Basic Settings
0 – 240 [min]
Range [units]
Related MINT
applications
Description Function will switch off the screen backlight after preset number of minutes.
Pressing any button on the controller or automatic start of the gen-set (e.g.
due to power management) will switch the backlight back on.
Default value is 15 minutes. It is possible to switch the function off by setting
0 (backlight will be on all the time).

16.1.3 Group: Comms Settings

Setpoint: ControllerAddr
Group Comms Settings
Range [units] 1 ... 32(8) [-]
Related All
applications
Description Unique identification number of a controller within a group of controllers
which are connected together via CAN2 bus (MINT, MC) or RS485 bus
(SPtM).
N :
OTE
Adjust the controller address to 1 if you have SPtM application and no other
controllers are connected to the RS485 bus.
N :
OTE
Do not use the same address for multiple controllers in the same group!
N :
OTE
Use the proper address when connecting to the controller from LiteEdit.
N :
OTE
Changing the address remotely (e.g. from LiteEdit) will cause connection
loss!
NT
InteliCompact , SW version 2.1
InteliCompact-NT-2.1-Reference Guide.pdf, ©ComAp – May 2015
168