Error Led Status - Epson AcuLaser C9200N Service Manual

EPSON AcuLaser C9200N
Table 1-7. Error Message and Troubleshooting
Message
Printing has stopped because
the photoconductor unit of
the specified color has
Replace Photocon uuuu
reached its lifetime.
Cannot be cleared by the
Start/Stop switch.
The waste toner box is at the
Replace Waste Toner end of its product lifetime.
Box
Cannot be cleared by the
Start/Stop switch.
Printing has stopped because
the fuser unit has reached its
Replace Fuser lifetime.
Can be cleared by the Start/
Stop switch.
Printing has stopped because
the transfer unit has reached
Replace Transfer Unit its lifetime.
Can be cleared by the Start/
Stop switch.
Printing has stopped because
the maintenance unit has
Replace Maintenance
reached its lifetime.
Unit
Can be cleared by the Start/
Stop switch.
PRODUCT DESCRIPTION
Downloaded from www.Manualslib.com
Explanation Remedy
Error LED flashing
Replace with a new
photoconductor unit of
the specified color.
Press the Start/Stop
switch to clear the error
and continue printing.
Error LED On
Replace with a new
photoconductor unit of the
specified color.
Replace with a new waste toner
box.
Error LED flashing
Replace with a new fuser
unit.
Press the Start/Stop
switch to clear the error
and continue printing.
Error LED On
Replace with a new fuser
unit.
Replace with a new transfer
unit.
Press the Start/Stop switch to
clear the error and continue
printing.
Replace with a new
maintenance unit. After
replacement, perform Reset
Maint Counter on the panel.
Press the Start/Stop switch
to clear the error and
continue printing.
manuals search engine
Table 1-7. Error Message and Troubleshooting
Message
Replace Feed Roller xxx
Set Release Lever to ppp
Position
wwww Open
List of Printer Messages
Explanation
Contact Service and replace
Printing has stopped because the paper feed roller. After
the paper feed roller has replacement, perform Reset
reached its lifetime. xxx Counter on the panel.
Can be cleared by the Start/ Press the Start/Stop switch to
Stop switch. clear the error and continue
printing.
Displayed when there is an
envelope print request after
printing plain paper, or a plain Open cover A, set the release
paper print request after printing lever to the position shown in
envelopes, prompting the user to the message, and close cover A.
set the release lever to the
correct position.
The error is cleared by closing
A cover is open. the cover specified. Refer to
Figure
Revision D
Remedy
1-8.
26
Confidential