Epson AcuLaser C9200N Service Manual page 204

EPSON AcuLaser C9200N
When the Mechanical Control Board (PWB-M) is replaced, relocate the Parameter
Chip (IC6).
Mount the Parameter Chip (IC6) of old Mechanical Control Board onto the new
Mechanical Control Board.
When the Parameter Chip (IC6) is mounted, precisely fit the directions of each
"A."
When installing the Mechanical Control Board (PWB-M) , secure the Harness to
the original location with the Wire Saddle.
When the Control Board is replaced, be sure to update the Firmware to the latest
version.
DISASSEMBLY AND ASSEMBLY
Downloaded from www.Manualslib.com
Parameter Chip (IC6)
4037F2C061DB
A
A
4037F2C534DA
Main Unit Disassembly/Reassembly
manuals search engine
Not Used
(CNSKF)
Not Used
(CNTM)
Be careful when assembling since there are some Connectors which are not used
on the Mechanical Control Board (PWB-M).
Revision D
204
Confidential