Epson AcuLaser C9200N Service Manual page 255

EPSON AcuLaser C9200N
[5]
3. Remove the Connector from the Cooling Fan Motor [3] and 1st Image Transfer Pressure/
Retraction Position Sensor [4].
4. Remove two Screws [5] and remove the Cooling Fan Motor [3] and Duct [6]
simultaneously.
There is a possibility to install the wrong Connector because the Connector for the
Cooling Fan Motor has a same number of Pins as the Connector for the 1st Image
Transfer Pressure/Retraction Position Sensor. Check the Connector condition before
removing and not to install the wrong Connector when assembling.
DISASSEMBLY AND ASSEMBLY
Downloaded from www.Manualslib.com
[4]
4038F2C126DA
Main Unit Disassembly/Reassembly
manuals search engine
[3]
[7]
[6]
5. Remove four Screws [7] and two Claws [8], and remove the Hopper Drive Assy [9].
[8]
[8]
4038F2C127DA
Revision D
[7]
[9]
255
Confidential