Epson AcuLaser C9200N Service Manual page 27

EPSON AcuLaser C9200N
Table 1-7. Error Message and Troubleshooting
Message
The installed CompactFlash
cannot be used on this printer or
it is a CompactFlash of less than
4 GB, or "No" is selected when
"Format Required" occurred.
This error also occurs under the
Invalid CompactFlash
following conditions for a
Error
CompactFlash with the
password lock function.
Password lock has failed.
Could not unlock the
password lock.
An error resulted as printing was
Can't Print Duplex specified with conditions where
duplex printing is not possible.
An error occurred because the
width of the paper set in the
feeder device was narrower than
the width set for printing. With
this printer, the error occurs
when the following conditions
are met at the same time.
Turn Paper Cassette 1 The width of the paper size
(2,3,4) specified for printing is
210.00mm or more.
The paper set is less than
210.00 mm wide.
The envisioned situation is when
normally horizontally set A4,
A5, B5, or LT is mistakenly set
vertically.
PRODUCT DESCRIPTION
Downloaded from www.Manualslib.com
Explanation Remedy
Turn off the printer, remove
the CompactFlash, and turn
on the printer.
Select "Yes" to format the
CompactFlash when "Format
Required" occurs.
This error is cleared by
pressing the Start/Stop
switch and the printer prints
in simplex.
When Auto Continue is on,
simplex printing starts after a
certain interval.
If printing does not continue,
cancel the job.
When the specified paper
size is correct
Remove the paper from the
cassette displayed and set the
correct paper. The error is
cleared and printing starts.
When the set paper is correct
Cancel the job for which the
error occurred, and resend
the data with the correct
paper size specified.
manuals search engine
cover F
cassette 1 (C1)
cassette 2 (C2)
cassette 3 (C3)
cassette 4 (C4)
cover D
List of Printer Messages
cover E2
cover E3
cover E4
paper path G
Figure 1-8. cover
Confidential
Revision D
cover B
cover A
MP tray
cover H
27