Epson AcuLaser C9200N Service Manual page 184

EPSON AcuLaser C9200N
C9 D9
[1]
The Transfer Belt Unit is included in "Transfer Kit" as a service part. Additionally, the
C H E C K
P O I N T
2nd Image Transfer Roller, Ozone filter, and Dust Filter are also included in "Transfer
Kit". Replace them at the same time. Refer to
"MAINTENANCE") (p331))
After the Transfer Belt Unit has been removed from the Main Unit for other purposes
than replacement, make sure to put it in the shipping plastic sheet whose color is
black, or wrap it in the light shielding cloth and store it in a dark place.
1. Open the Right Door.
2. Remove two Screws [1] and release the Lock of the Transfer Belt Unit [2].
DISASSEMBLY AND ASSEMBLY
Downloaded from www.Manualslib.com
Transfer Belt Unit
[2]
4039F2C005DA
(Refer to Chapter 6
Main Unit Disassembly/Reassembly
manuals search engine
[3]
[4]
[5]
3. Hold the both sides and lift it to take out the Transfer Belt Unit [3] a little.
4. Hold the position [4] as shown in the figure above and remove the Transfer Belt [5].
When installing the Transfer Belt Unit, be careful of the following points.
Insert the Transfer Belt with care not to allow its docking gear to be damaged by
hitting it against the rail or associated part.
Do not touch the surface of the Transfer Belt.
Revision D
4039F2C006DA
[4]
184
Confidential