Epson AcuLaser C9200N Service Manual page 321

EPSON AcuLaser C9200N
UPDATE METHOD 1
Required Tool
Computer
USB cable
Firmware Update Tool
Control Panel Special Operation
Required
Step Explanation
1 Print a Configuration Status Sheet, and check
the current version.
2 After turning the power off for both the
printer and computer, connect them with a
USB cable.
Before connecting the USB cable,
make sure to disconnect other
interface cables from the printer.
3 Turn the computer on and copy the firmware
data file (CRB format) to any directory of the
computer.
4 Turn the printer ON while holding down the
[Start/Stop], [Job Cancel], and [Down]
buttons.
(The printer will start up in "Controller
Firmware Update Mode".)
ADJUSTMENT
Downloaded from www.Manualslib.com
LCD Panel
---
---
---
manuals search engine
Step Explanation
5 Start up the Firmware Update Tool.
Specify the port and the program update file
on the selection window of the tool.
6 Click [Send] on the Firmware Update Tool
screen.
7 "Completion" pop-up window will be
displayed when the data transfer is finished.
Click [OK].
Confirm that both the old and new firmware
versions are displayed on the LCD, and press
the [OK] button on the control panel to start
the program update.
Firmware Update
Revision D
LCD Panel
---
321
Confidential