Epson AcuLaser C9200N Service Manual page 165

EPSON AcuLaser C9200N
[4]
3. Hold the both sides and lift it to take out the Transfer Belt Unit [3] a little.
4. Hold the position [4] as shown in the figure above and remove the Transfer Belt [5].
When installing the Transfer Belt Unit, be careful of the following points.
Insert the Transfer Belt with care not to allow its docking gear to be damaged by
hitting it against the rail or associated part.
Do not touch the surface of the Transfer Belt.
DISASSEMBLY AND ASSEMBLY
Downloaded from www.Manualslib.com
[3]
4039F2C006DA
[4]
[5]
manuals search engine
Insert the Transfer Belt Unit into the Main Unit completely and make sure the
Drive Gear of the Transfer Belt Unit matches with that of the Main Unit. And then,
secure them with Screws. If they are secured even though both Drive Gears have
not been matched, the Main Unit may be damaged when closing the cover.
Main Unit Disassembly/Reassembly
Matched Not Matched
Revision D
165
Confidential