Error Code Is Displayed On The Status Menu - Epson ET-L6550 Series User Manual

Solving Problems
There are some problems with fax connection and fax settings.
Solutions
Try the resolutions for fax connection and fax settings.

Error Code is Displayed on the Status Menu

If a job does not complete successfully, check the error code displayed on the history of each job. You can check the
error code by selecting Job/Status, and then selecting Job Status. See the following table to find the problem and
its solution.
Code Problem
001 The product was turned off by a power failure.
106 Cannot print from the computer due to the access
control settings.
107 User authentication failed. The job has been
canceled.
108 Confidential job data was deleted when the printer
was turned off.
109 The received fax was already deleted.
110 The job was printed on one side only because the
paper loaded does not support double sided
printing.
201 The memory is full.
202 The line was disconnected by the recipient machine.
203 The product cannot detect the dial tone.
>
The Printer Does Not Work as Expected
>
Error Code is Displayed on the Status Menu
Solution
-
Contact your printer administrator.
❏ Make sure that the user name and password are
correct.
❏ Select Settings > General Settings > System
Administration > Security Settings > Access
Control. Enable the user restriction function, and
then allow the job without an authentication
information.
-
-
If you want to perform 2-sided printing, load paper
that supports 2-sided printing.
❏ Print received faxes from Job Status in Job/
Status .
❏ Delete received faxes saved in the inbox from Job
Status in Job/Status.
❏ If you are sending a monochrome fax to a single
destination, you can send it by using Direct Send.
❏ Divide your originals in two or more to send them
in several batches.
Wait for a while and then try again.
❏ Make sure that the phone cable is connected
correctly and the phone line is working.
❏ When the printer is connected to the PBX or the
terminal adapter, change the Line Type setting to
PBX.
❏ Select Settings > General Settings > Fax
Settings > Basic Settings > Dial Tone
Detection, and then disable the dial tone setting.
219