EPSON AcuLaser C9200N
4. Reinstall the Stopper [7].
When reinstalling the Stopper, use care so that both ends of the Stopper will not open
but stay parallel as shown in the figure above.
Keep using the Stopper after once stretched out may cause uneven pitch or other
image troubles.
DISASSEMBLY AND ASSEMBLY
Downloaded from
www.Manualslib.com
○
×
[7]
4038F2C115DA
manuals search engine
5. Reinstall the Gear [8].
6. Connect the Connector and the Flat Cable.
When reinstalling the Gear [8], make sure that the Claw of the Gear is fit in.
When installing the Harness, make sure the Harness is hooked along with the
Harness guide referring to the figure above.
Main Unit Disassembly/Reassembly
Revision D
[8]
4038F2C116DA
191
Confidential