Beeper; Mounting Using Front Block - Microscan Visionscape HE1600T Manual

TABLE 2–5.
Mode
•
•
•
•

Beeper

The Visionscape
Pass/Fail conditions.
Mounting & Wiring the Visionscape
HE1600T
• Mount the camera securely in its camera stand (not supplied).
• Make sure the camera is mounted at the correct distance for the optics
you've purchased.
• Connect the Ethernet cable (X4) and the power cable (X1) to the
Visionscape
Connect the Visionscape

Mounting Using Front Block

Note: Do not insulate the mounting block. The mounting block of the
Visionscape
metal-to-metal contact is required for effective cooling. Refer to Appendix C,
"Specifications," for mounting block dimensions.
You can mount the Visionscape
located on the top, bottom, and each side of the front block, as shown in
Figure 2–4.
Rev. 1H, Mar 2009
Mode/Status LED Power-On Sequence & Error Codes
Fail Pass Trig
•
•
®
Smart Camera's beeper is user configurable and indicates
®
Smart Camera HE1600T (see "Rear Panel" on page 2-5).
®
Smart Camera HE1600T to a 24V power supply.
®
Smart Camera HE1600T is part of the heat dissipation system, and
®
Visionscape® Smart Camera HE1600T Guide
Visionscape® Smart Camera HE1600T
Test Performed
FPGA Video Buffer Test
• FPGA DMA Transfer Test
FPGA Expose Done Interrupt Test
• FPGA Read Done Interrupt Test
®
Smart Camera
Smart Camera HE1600T using the M4 holes
2
2-9