Cisco D9858 Installation And Configuration Manual page 198

Chapter 5 Web GUI Setup and Monitoring
WSS Mode
Passthrough
Auto:Create
Auto:Modify
Suppress
7 Check the Enable Banner Display check box to display alarms and warnings on
the on-screen display (for example, TV monitor).
8 Click Apply.
Viewing the Video Status
The Video Status area displays the current video settings, and the encoding, bit rate,
FPS and aspect ratio of the incoming signal. The fields are read-only. The following
table describes the video status information displayed:
Video Status
Primary Video
Output
Standard Definition
Output
Aspect Ratio
Wide Screen
Signalling
Encoding Format
Bit Rate (Mbps)
Frame Rate (fps)
3:2 Pulldown
176
Description
Passes WSS unmodified as received by the receiver.
Creates WSS to output the correct aspect ratio when performing
aspect ratio conversion.
If WSS is present in the input stream, it is modified to output the
correct aspect ratio when performing aspect ratio conversion. If
WSS is not present in the input, no WSS will be present in the
output.
Removes WSS output.
Description
Indicates the actual output video format (Auto, HD 720p, HD 1080i,
or SD).
Displays the actual standard definition format of the primary video
output if the PV Output is set to SD.
Displays the standard definition aspect ratio of your TV monitor.
Displays the Wide Screen Signaling output mode.
The input stream type of the received signal/program.
Indicates the bit rate of the input video stream, in Mbps.
Indicates the frame rate of the input video stream.
Indicates whether 3:2 pulldown is detected, was recently detected,
or not detected in the input video stream (Yes, Recent, or No).