Cisco D9858 Installation And Configuration Manual page 223

8 If Ctl By Table is selected as the PSI Table Output Option, click Table Options
to configure the DPM table options. The DPM Table Options dialog box is
displayed.
Select the tables which will be passed, dropped, regenerated or passed with rate
control (PwRC) from the ASI Output. For more information on the table options,
see PSI Table Settings.
The CDT is different from the other tables listed because the CDT is referred to
within the PMT, rather than outside the PMT. Check the Block CDT Output
check box to override the DPM PID map configuration for CDT PI Ds and to
always drop all CDTs. Otherwise, uncheck the Block CDT Output check box to
permit the output of CDTs following the configured DPM PID map
configuration and all other DPM constraints.
9 From the PSI Regeneration Option drop-down list, choose whether to
regenerate the PSI tables to the output. You can choose Always to regenerate all
the tables or As Needed to only regenerate the tables if the content has changed.
10 Click OK.
11 Click Apply.
12 Click Copy To MOIP to copy all the DPM data from the ASI output to the MPEG
over IP output.
Configuring Transport Stream Information
201