Transcoder Versions - Cisco D9858 Installation And Configuration Manual

Menu Item
FPGA Version,
Select, Erase

Transcoder Versions

The following are the version numbers applicable to the Transcoder printed circuit
board.
Menu Item
Host Root FS, Host
Kernel
Host Boot
Interface
FPGA
CPLD
MPEG2 FW
H.264 App Curr 1,
H.264 App Curr 2
H.264 App Safe 1 and
H.264 App Safe 2
H.264 Boot 1 and
H.264 Boot 2
Description
FPGA Version - Select between all versions of the FPGA code
loaded on the current unit.
Select - Select and then scroll to Yes to reboot the unit and load
the selected FPGA code. You will be prompted to continue or
abort this operation.
Note: Selecting an FPGA code will cause the unit to reboot
and interrupt service.
Erase - Select to erase the selected FPGA code. You will be
prompted continue or abort this operation. You cannot erase
the safe FPGA code or the current FPGA code. While an FPGA
code is being erased, the busy indicator will appear. You
cannot erase another FPGA code until it is complete.
Note: You cannot reboot or remove applications during a
download or erase. You must stop the download first. For
more information on aborting the download, see Setup Menu:
Admin (on page 58).
Description
Indicates the Host Root FS and Kernel version numbers.
Indicates the Host Boot version number.
Indicates the Interface version number.
Indicates the Field Programmable Gate Array (FPGA)
version number.
Indicates the CPLD version number.
Indicates the MPEG-2 FW version number.
Indicates the current H.264 transcoder path 1 and H.264
transcoder path 2 application version number.
Indicates the factory loaded H.264 transcoder path 1 and
H.264 transcoder path 2 application version number.
Indicates the H.264 transcoder path 1 and H.264 transcoder
path 2 boot version number.
Versions Menu
131