Cisco D9858 Installation And Configuration Manual page 298

Chapter 6 Service and Maintenance
Alarm Message
Type
Transcoder Set
Status
Transcoder Set
Status
Transcoder Set
Status
Transcoder Set
Status
Transcoder Set
Status
276
Message Cause/Remedy
Transcode Not Cause: Possible
Started: FPGA hardware or
version mismatch software fault.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
Transcode Not Cause: Possible
Started: Decoder hardware or
failed to load software fault.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
Transcode Not Cause: Possible
Started: Encoder hardware or
failed to load software fault.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
Transcode Not Cause: Possible
Started: Invalid hardware or
production
software fault.
information
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
Transcode Not Cause: Possible
Started: hardware or
Communication
software fault.
Failure
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
Description Severity
Transcoder Major
FPGA
software
version does
not match the
hardware
version.
Unable to load Major
or execute the
decoder
software.
Unable to load Major
or execute the
encoder
software.
Transcoder Major
production
information is
corrupted.
There was an Major
error
establishing
connection
with the
transcoder.
ID
1500
1500
1500
1500
1500