Table of Contents
Advertisement
Setting Up the MPEG over IP Auto Synchronization Options
The MoIP Auto Sync area allows you to configure the DPM without editing each
output channel and PID separately.
1
In the MPEG over IP Output page (Transport Stream > MPEG over IP Output),
refer to the MoIP Auto Sync area.
2
From the Enable Auto Fix for Collision drop-down list, choose Yes for the DPM
to resolve channel and PID collisions automatically on the transport outputs.
New values are assigned to the parameters that caused the conflict. The new
assigned values are not used by any incoming transport or other PE outputs. If a
collision is detected, you can review the new changes and click Apply to accept
the new changes.
Choose No and a detailed list of all the conflicts is displayed in the Output
Channel and PID Conflicts table (click View Conflicts) when a conflict occurs.
You can then resolve the conflicts manually.
3
From the Enable Fixed Output drop-down list, choose Yes for the DPM to assign
new values for all the output channels and PIDs according to the Fixed Output
Options table when you Resynchronize All. Click Fixed Output Options to
configure the MoIP Fixed Output Options:
a
From the Use Input Channel Numbers drop-down list, choose Yes to use the
input channel numbers. Otherwise, choose No (default) to use the first
channel and channel offset assigned below.
i
In the First Channel Number field, set the first PE channel number to
use. By default, the channel is set to 1.
Configuring Transport Stream Information
207
- Quick Links:
- Logging on to the Web Gui
Hide quick links:
Advertisement
Table of Contents
