Quick Setup Instructions For Rf Acquisition - Cisco D9858 Installation And Configuration Manual

Chapter 2 Quick Setup - Read Me First!

Quick Setup Instructions for RF Acquisition

1 Press MENU to display the Main menu.
2 Press
menu. Press SELECT.
3 To setup the ASI input port, go to Step 4. To setup the RF1 input port, go to Step
5.
4 Press SELECT three times. Press
SELECT. Go to Step 11.
5 Press SELECT. Press
port parameter to Act (Activate). Press SELECT.
6 Press
your application. If no change is needed, go to Step 7. If required, you may
modify these settings. Use
Press SELECT. Use the numerical keypad to enter new frequencies. Press
SELECT.
7 Press
Use
choose Rolloff. Press SELECT. Use
8 Press
RF frequency. Press SELECT. Press
SELECT. Enter the symbol rate. Press SELECT. If DVB-S2 is used, proceed to
Step 9. If DVB-S is used, press
select AUTO. Press SELECT.
9 Press
SELECT. Enter the value. Press SELECT.
10 Press . Press SELECT. Use
RF1 port is capable of providing 13V or 18V. Press SELECT.
11 Press MENU three times to acquire the network. The transcoder will search for
the signal and display "Acquisition Successful". It will find the first available
channel on the network.
12 Press
Main: Setup menu; Abandon & Exit will go back to the last menu accessed with
the original parameters; Cancel will go back to the last menu accessed with
changes saved.
13 If the front LED is solid green, the unit is authorized. Proceed with Assigning a
Program Channel to a PE (Program Entry) (on page 15). If the front LED is
flashing green, the unit is unauthorized. Please contact your service provider and
provide the Tracking ID number for authorization. The Tracking ID can be found
on the ABOUT menu. To locate the Tracking ID, press MENU, press
then press SELECT twice. Make a note of the Tracking ID number. Press MENU
three times to return to the startup screen.
14
to go to the Setup menu. Press SELECT. Press
to go to RF1. Press SELECT twice. Use
to move to the LO1, LO2, Crossover menu. Verify these parameters for
five times to move to the Modulation and Rolloff menu. Press SELECT.
to choose DVB-S or DVB-S2. Press SELECT. If DVB-S2 is used, press
to move to the Freq., Sym Rate, and FEC menu. Press SELECT. Enter the
twice to move to the Net ID menu. Press
to move to Save & Exit. Press SELECT. Save & Exit will return you to the
to set the ASI port to Act (Activate). Press
to move to the parameter that you want to modify.
to choose the value. Press SELECT.
to move to the Sym. Rate menu. Press
to set up the FEC. Press SELECT. Use
to change the LNB power, if needed. Only the
to move to the TS Input
to set the RF1
to choose Net ID. Press
to
to
twice, and