Cisco D9858 Installation And Configuration Manual page 207

7 From the Relay Mode drop-down list, choose the relay mode that can be
programmed to respond to an Alarm state, Warning statue, or the state of one of
the eight cue trigger pins. The response is generated at the Cue Tone/Relay
output on the rear panel of the receiver. The following table shows what the
possible field settings are and their relationship to the receiver output:
Relay Mode
Alarm
Trigger
8 If the Relay Mode is set to Trigger, choose the cue trigger bit/pin that will
activate the relay from the Relay Trigger Bit drop-down list (1 to 8).
9 Click Apply.
Condition
Unit Power Off
Alarm State
No Alarm
Active (selected in PNC) Close
Inactive
Setting up Audio and Video Information
Relay Contact
NC - C C-NO
Open Close
Open Close
Close Open
Open
Open Close
185