Cisco D9858 Installation And Configuration Manual page 86

Chapter 4 Front Panel Operation
Menu Item
Tune Mode
CA Ctl
RF1, RF2, RF3, RF4 (RFx) Input
Menu Item
RFx Active (RF1,
RF2, RF3, RF4)
Tune Mode
64
Description
Select the tables required for the service
list creation and signal acquisition.
Sets how the conditional access will
attempt to descramble the scrambled
programs.
Description
Select the input to be active.
Note: Setting a new input to be active will
deactivate the currently active input.
Select which tables are required for the service
list creation and signal acquisition.
Note: When editing the tuning, the device is in
a transient state while acquiring tuning
information and channel lists, and so on. The
receiver reverts to the previous set of tuning
settings/information and channels until these
changes are either saved or abandoned.
Parameters
Basic - Requires NIT to be present.
Auto - Uses all the service list
tables and it will acquire if any
service list tables are present.
Custom - Uses the Custom Tuning
parameters, specified by the user.
The default is Basic.
Std - In standard mode, if a
program is not authorized, even if
some services are not scrambled,
the whole program will not be
authorized.
Open - In open mode, if a program
is not authorized, services in the
program that are not scrambled
will still be available.
Parameters
Act or No.
Basic - Requires NIT to be
present.
Auto - Uses all the service
list tables and it will
acquire if any service list
tables are present.
Custom - Uses the Custom
Tuning parameters,
specified by the user.
The default is Basic.