Cisco D9858 Installation And Configuration Manual page 96

Chapter 4 Front Panel Operation
Protocols
The Protocols menu allows you to control remote access protocols (Telnet, SSH, HTTP, DTX,
and SNMP) to the IRD.
Menu Item
Telnet
SSH
HTTP
SNMP
MPE
74
Description
Controls Telnet access to the
IRD. Select Enable to allow
Telnet connections. Select
Disable to disable the listener for
the Telnet port.
Controls SSH access to the IRD.
Select Enable to allow secure
shell connections. Select Disable
to disable the listener for the
SSH port.
Controls HTTP access to the
IRD. Select Enable to allow web
connections. Select Disable to
disable the listener for the HTTP
port.
Controls SNMP access to the
IRD. Select Enable to allow
SNMP connections. Select
Disable to disable the listener for
the SNMP port.
Sets whether the MPE data is
forwarded to the network.
Note: The transcoder supports
up to a maximum of 10 Mbps
throughput when forwarding
1500 byte packets.
Port Number Parameters
TCP port #23 Enable (default) or Disable
TCP port #22 Enable (default) or Disable
TCP port #80 for Disable - Disables the
HTTP listener for the HTTP port.
TCP port #443 Enable (default) - Allow
for HTTPS. web connections.
Secure - Encrypted access
to the webserver (HTTPS).
For more information, see
Protocol Control Settings
(on page 231).
UDP port #161 Enable (default) or Disable
N/A Fwd None - The MPE data
is not forwarded to the
network.
Fwd All - All the MPE data
is forwarded to the
network.
Fwd Filtered - Only the
MPE data from the defined
Static Multicast Filtering
table is forwarded to the
network. For more
information on configuring
the Static Multicast
Filtering table, see To Add a
Static Multicast Filtering
(on page 237).