Connecting The Ac Power To The D9858 Transcoder - Cisco D9858 Installation And Configuration Manual

Chapter 3 Installation

Connecting the AC Power to the D9858 Transcoder

1 Connect the power cord (supplied with the D9858 transcoder) between the rear
panel power receptacle and a 100 to 120/200 to 240 V AC power outlet.
2 Make sure that the power cable is connected to protective ground. See
Grounding (on page 21) for more information.
The D9858 transcoder is equipped with one power supply located in the rear of the
chassis. Note the location of the power supply in the event of alarms/warnings
resulting in replacement of a power supply. Alarm messages appear in the Message
Log.
22