Cisco D9858 Installation And Configuration Manual page 115

Menu Item Description
Config Type Indicates the current DPM
configuration change by a
user after changing the
Output Mode.
Descramble Select whether the output
will be descrambled if the
Mode
input is scrambled.
Insert Null Select whether to insert
null packets into the
Packet
output to maintain output
at a constant bit rate.
Auto Map Sets whether the DPM
resolves the channel and
PID collisions
automatically on the
transport outputs. New
values are assigned to the
parameters that caused the
conflict. The new assigned
values are not used by any
incoming transport or
other PE outputs. If a
collision is detected, you
can review the new
changes before applying
the new changes.
Parameters
Edited by User - DPM changes were made.
Unmodified - No changes were made after setting
a new Output Mode.
Auto Re-Mapped - Output map changed
automatically to fix the output channel or PID
conflicts at the time of setup.
Changed by Uplink - DPM output changes were
initiated by an encoder.
Scrambled - The output channel will remain
scrambled even if the PE is authorized and can
descramble the channel.
Descrambled - Descrambles the output channel,
and passes in-the-clear channels.
The default is Descrambled.
Yes or No
Note: We recommend that you set the Insert Null
Packet to Yes, especially if the Output Mode is set
to Transcoding.
Yes or No
Setup Menu
93