Cisco D9858 Installation And Configuration Manual page 297

Alarm Message
Type
Signal Status Set
Signal Status Set
Signal Status Clear
Signal Status Clear
Transcoder Set
Status
Transcoder Set
Status
Message Cause/Remedy
Signal is lost Cause: Loss of
ASI/RF lock. Loss
of Transport data.
Invalid frequency
parameters.
External to IRD.
Remedy: Check
tuning parameters
and ASI/RF cables.
Tuning Parameters Cause: Loss of
ASI/RF lock. Loss
Invalid
of Transport data.
Invalid frequency
parameters.
External to IRD.
Remedy: Check
tuning parameters
and ASI/RF cables.
Signal is locked –
Tuning Parameters –
Valid
Transcode Not Cause: Possible
Started: Restart hardware or
Timeout software fault.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
Transcode Not Cause: Possible
Started: FPGA hardware or
failed to load software fault.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
Description Severity
Loss of signal Minor
One of the Minor
tuning
parameters is
invalid
Signal OK Minor
Tuning Minor
parameters
are valid
No response Major
was received
from the
transcoder
during the
boot process.
Unable to load Major
or execute the
transcoder
FPGA
software.
ID
1000
1000
1000
1000
1500
1500
275