Cisco D9858 Installation And Configuration Manual page 216

Chapter 5 Web GUI Setup and Monitoring
i
ii In the First ES PID Numbers Offset field, set the offset of the first ES PID
d From the Use Input PMT ES Stream Order drop-down list, choose Yes to
assign the ES PID according to the incoming PMT order. Otherwise, choose
No to use the reserved PIDs defined below.
i
e Click OK.
4 From the Enable Auto Map For Auxiliary PEs drop-down list, choose Yes for
the DPM to set the output actions for all the Auxiliary PEs to MAP when the
Output Mode is set to Transcode. If the Enable Fixed Table Output is set to Yes,
the output configuration for the auxiliary PEs is determined by the fixed output
table options when you resynchronize the output channels and PIDs to match
the input programs.
Note: The DPM resolves any output conflicts automatically, even if the Enable
Auto Fix for Collision is set to No.
5 Click Apply.
Viewing the ASI Output Status
The ASI Output Status area displays the current Output Rate (0 to 213 Mbps) and
the available bit bandwidth (Free Bandwidth), in Mbps.
194
In the First Channel First ES PID Number field, set the first ES PID
number. The default is 101.
of subsequent channel numbers. For example, if the First ES PID Number
is set to 101 and the ES PID Numbers Offset is set to 100, then the first ES
PID number is 101, and the second ES PID number is 201.
In the PCR, VID, AUD, SUBT, VBI, DPI, MPE, TTX, DATA, LSD, CDT,
ETV fields, enter the number of PIDs for the specified streams (PCR, VID,
AUD, SUBT, VBI, DPI, MPE, TTX, DATA, LSD, CDT, ETV) in one
channel.