Cisco D9858 Installation And Configuration Manual page 343

Warning Message
Type
Restore Failure Set
Reason
Restore Failure Set
Reason
MPoIP Bitrate Set
Port #<n>
MPoIP Bitrate Clear
Port #<n>
MPoIP Bitrate Clear
Port #<n>
Message Cause/Remedy
Not Accepted Cause: Import file is
either for a different
product or the structure
was not compatible with
this unit.
Remedy: Verify that the
correct import file is
being used and was
created by this product.
Verify that the file
structure has not been
corrupted. If the
problem persists, notify
Cisco Services.
Bad Content Cause: Import file may
be corrupted, or from a
different version of
application software.
Remedy: Verify that the
correct import file is
being used and was
created by this product.
Verify that the file
structure has not been
corrupted. If the
problem persists, notify
Cisco Services.
Total configured Cause: The aggregated
output is MPEG over IP
marginal or too bandwidth on Port <n>
high is too high.
Remedy: Re-configure
the output rate of the
stream(s) to be within
90% of the link speed on
Ethernet port <n>.
Total configured –
output is normal
Inactive port, –
monitoring
stopped
Description
Import file was
rejected and import
did not occur
Item in import file is
not valid for this
software and import
did not occur
Configured MPEG
over IP bandwidth is
very close or higher
than the Ethernet port
<n> link speed. This
condition can trigger
the actual MPoIP
overflow.
–
–
ID
89100
89100
92000
92100
92000
92100
92000
92100
321