3
The Warning Setup area displays a list of the warning messages. For more
information on warning messages, refer to D9858 Transcoder Alarm Messages
(on page 272).
4
Set Enable/Disable to Yes and the warning message will be reported. Set to No
and the warning is disabled and the Relay and Trap settings are ignored.
Note: Enable/Disable must be set to Yes for the Relay and Trap settings to be
functional.
5
If current warning is enabled, choose Yes from the Trap drop-down list and the
SNMP trap message will be sent when the warning is set or cleared.
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the warning is disabled (Enb is set to No).
6
If current warning is enabled, choose Yes from the Relay drop-down list for the
rear panel alarm relay to be triggered when the warning is set or cleared.
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the warning is disabled (Enb is set to No).
7
Click Apply.
Configuring System Settings
245