Cisco D9858 Installation And Configuration Manual page 78

Chapter 4 Front Panel Operation
Menu Item
Signal Lock Timer
Verify Timer
Backup Channel Status
Menu Item
PE
Backup Channel
Transport #
Backup Transport Status
Menu Item
Backup
Input, NetId, Freq
(GHz), SymRate,
FEC, OrbPos, E/W,
Pol, Modulation,
Rolloff, Config by
56
Description
Indicates the time, in seconds, the unit must wait
for a signal lock before declaring that the signal is
not usable and move on to the next search location
in the search path.
If the Profile is set to User, it displays the time set
by the local unit.
If the Profile is set to Uplink, it displays the time
set by the PNC uplink. But if the unit is not
connected to the uplink, the default value of the
unit is displayed.
Indicates the time, in seconds, the unit must wait
for the PAT table to verify the signal has a valid
transport.
If the Profile is set to User, it displays the time set
by the local unit.
If the Profile is set to Uplink, it displays the time
set by the PNC uplink. But if the unit is not
connected to the uplink, the default value of the
unit is displayed.
Description
Displays the program entry.
Displays the channel number assigned to the
selected backup transport.
Displays the backup transport number for the
program entry selected.
Description
Indicates the configured backup transport entry
number.
For information on the tuning parameters, see
Status Menu: TS Input (on page 48).
Note: The RF input must be configured to match
the bandwidth of the backup parameters.
Parameters
5 to 255
10 to 255
Parameters
PE1 or PE2
–
1, 2, or 3
Parameters
1, 2, or 3
–