Copying Between Asi And Mpegoip Dpm Settings; Configuring The Program Entries - Cisco D9800 Configuration Manual

Configuring the Transport Stream Information
For more information, see
Step 6 Apply the changes.

Copying between ASI and MPEGoIP DPM Settings

Step 1 Do one of the following:
• Web GUI (single-stream unit): From the D9800 web GUI, choose Transport Stream > Digital Program Mapping
for ASI or MPEG over IP output.
• Web GUI (multi-stream unit): From the D9800 web GUI, choose Transport Stream > Digital Program Mapping
for ASI 1 Output, ASI 2 Output, IP Data 1/Data 2 Output, or IP Data 3/Data 4 Output.
• Front Panel: From the D9800 front panel, choose Setup > Outputs > TS Out > DPM > Global.
Step 2 For a single-stream unit, do one of the following:
• Click Copy To MOIP, or choose the Copy: > ASI->MOIP front panel menu, to copy all the DPM data from the
ASI output to the MOIP output.
• Click Copy To ASI, or choose the MOIP->ASI front panel menu, to copy all the DPM data from the MOIP output
to the ASI output.
For a multi-stream unit, do one of the following:
• Web GUI: Click Copy and check the output check boxes to copy all the DPM data from the output displayed in
the From field, to the outputs selected in the To field. Click Apply.
• Front Panel: Choose Copy: From to select the output from which you want to copy all the DPM data, and then
choose Copy: To to select the output to which you want to copy all the DPM data. Choose Yes from the Apply
menu to apply the changes.

Configuring the Program Entries

Step 1 Do one of the following:
• Web GUI (single-stream unit): From the D9800 web GUI, choose Transport Stream > Digital Program Mapping
for ASI or MPEGoIP.
Setting the PSI Table Options, on page
Cisco D9800 Network Transport Receiver Version 3.01 Installation and Configuration Guide
Copying between ASI and MPEGoIP DPM Settings
15.
17