Cisco D9858 Installation And Configuration Manual page 299

Alarm Message
Type
Transcoder Set
Status
Transcoder Set
Status
Transcoder Clear
Status
Transcoder Set
Verification
Transcoder Set
Verification
Transcoder Set
Verification
Message Cause/Remedy
Transcoder Not Cause: Possible
hardware or
Detected
software fault.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
Lost Contact With Cause: Transcoder
resetting. Possible
Transcoder
hardware or
software fault.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
Transcoder Started –
Post reported Cause: Possible
errors hardware issue.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
Post data Cause: Possible
unavailable hardware issue.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
Application Cause: Possible
checksum failed hardware issue.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
Description Severity
Messages Major
were not
received from
Transcode on
boot.
Messages Major
were not
received from
Transcoder
after it
previously
received
messages.
– Major
The Major
transcoder
power-on self-
test reported
errors.
The Major
transcoder
was unable to
read the
results of the
power-on self-
test.
The Major
transcoder
software
failed
verification.
ID
1500
1500
1500
1600
1600
1600
277