Data Station Run Screen Soft Keys - Abbott CELL-DYN 3000 Operator's Manual

Operating Instructions

Data Station Run Screen Soft Keys

CLEAR
ORIFICE
CLEAR
FAULT
5-58
Search Book TOC
A brief description of the function of each key is given in this section.
Instructions for running samples and using the Work List are given in the
Sample Analysis sections of this chapter.
The [CLEAR ORIFICE] key is used to initiate a special cleaning
sequence that flushes the RBC/PLT aperture to remove obstructions. The
sequence takes approximately 35 seconds. When the [CLEAR
ORIFICE] key is pressed, the message CLEANING RBC ORIFICE is
displayed in the Status Box.
The [CLEAR ORIFICE] key label changes to [CLEAR FAULT]
whenever a system fault occurs (e.g., Diluent Empty). This key is used to
clear the fault message and return the Analyzer to the "Ready" status
after corrective action has been taken.
NOTE: A message describing the fault appears in the bulletin
line. A list of fault conditions and corrective action is given in
Chapter 10,
Work List OFF
Bar Code On
# 4-DIGIT SPECIMEN
BAR CODE ID
793 1793
794 1794
795 1795
796 1796
797 1797
798 1798
799 1799
800 1800
WORK LIST BAR CODE INSERT/
ON OFF DELETE
Figure 5.27:
Go Back
Troubleshooting, of this manual.
WORK LIST
Ready
SPECIMEN
NAME
DELETE PURGE
ALL COMPLETED
Work List Screen
Dec 18 1992 09:48
Operator ID 734
Sequence # 0630
LIMIT PARAM STATUS RACK-TUBE
1 1
1 1
1 1
1 1
1 1
1 1
1 1
1 1
WORK LIST PRINT
SET UP WORK LIST
CELL-DYN® 3000 System Operator's Manual
9140240E — May 1995
Chapter 5
RETURN