Data Station Run Screen - Abbott CELL-DYN 3000 Operator's Manual

Chapter 5

Data Station Run Screen

CELL-DYN® 3000 System Operator's Manual
9140240E — May 1995
Search Book TOC
The Upper Left Corner of the
samples displays the following data entry fields on lines 1–5:
1. NEXT ID
2. PATIENT
NOTE: If "patient" is not the selected specimen type, then a
different data entry field appears on line 2.
• "Res RBC" replaces "PATIENT" when Resistant RBC is
selected.
• "QC Filename" replaces "PATIENT" when QC Specimen is
selected. The number of runs in the QC file and total file
space are displayed to the right of the type as in the
following example: 31/120.
• "Background" replaces "PATIENT" when Background is
selected.
• "ELEC BKGND" replaces "PATIENT" when Electrical
Background is selected.
3. SEX (M/F):
/--/--
4. Dr.
XB:
5. PARAM:/
LIMITS:
NOTE: The Parameter and Limit sets applied to the sample
may be changed after the sample has been run. Refer to the
description of the
"Using the Data
Go Back
Data Station RUN Screen
This field is used to enter the ID number for the
next sample to be run. (Up to 12 characters may be
entered.) If the Auto Increment feature is active,
AUTO is highlighted at the end of the field. Refer to
the discussion in the Sample Identification
of the Sample Analysis
more information about this feature.
This field is used to enter the patient's name or
identification. (Up to 16 or characters may be
entered.)
These fields are used to enter the sex andDOB: --
birth date of the patient.
This field is used to enter the name of the
patient's physician. (Up to 22 characters may be
entered.)
If the XB analysis is enabled, the XB file status is
displayed to the right of the <DR> entry field.
These fields display the number (1–4) of the
Parameter and Limit sets that will be applied
to the sample results.
Data Log [EDIT SPECIMEN] key
Log" section of this chapter.
Operating Instructions
for patient
section
section in Chapter 5 for
given in the
5-53