To debug NMEA GPS data, connect PORT3 cable to COM2 port, or connect PORT2 cable and
enable nmea log mode, or via USB cable activating nmea log mode by sending .log_nmea:1
command in terminal.
20
FM6320 REMOTE LOG
LOG BOOK
Two types of log book: online, offline.
Online log book is initiated using command log2srv and set right configuration. Device establish
GPRS connection and activates link to server, log started to stream to server until set time is
elapsed. To stop streaming immediately log2srvstop is used.
Offline log book is initiated using command log2srv and set right configuration. Device start log
writing to flash, this action is performed until set time is elapsed.
To read offline log log2srvstart command is used. It sends log to earlier preconfigured server
(log2srv). Offline log sending also can be terminated using log2srvstop command.
COMMANDS
"SMSlogin<space>SMSpassword<space>log2srv<space><enable>,<mode>,<APN>,<userna
me>,<password>,<IP>,<port>,<TMO>,<Log mode>"
o <enable> - enable (1), disable(0);
o <mode> -
silent (0) – connect to server and send "Hello" message (all "Terminal"
commands can be used)
echo_time (1) – send log with lines, where is TIME "for example: -
[2013.1.23 14:49:45]-[PERIODIC.BAN.LIST.INFO]:"
echo (2) – send log with lines where is no TIME "for example: [DIN1.FUNC]-
>Waiting for DIN1 to be ON"
echo/echo_time (3) – send full log
modem (4) – send just AT commands
NMEA (5) – send NMEA log.
Figure 74 Terminal Window
133