Table of Contents
Advertisement
o Hysteresis – record is generated when increasing parameter value becomes higher
than High value, and decreasing becomes less than Low value
o Event on exit – record is generated when parameter value becomes higher than
High value or lower than Low value;
o Event on entrance – record is generated when parameter value becomes between
High and Low values;
o Event on both – record is generated when parameter value crosses High or Low
values;
Low – allows to choose low value for Data acquisition;
High – allows to choose High level for Data acquisition;
13.4.2 CAN monitoring
To start CAN bus monitoring mark Monitoring check box. Table of available CAN
messages will appear (Fig. 61). Data from CAN bus will be updated every 3 seconds. In order to
see only desired data open "Monitoring filters" menu (Figure ).
Figure 61 CAN data table
Figure 62 Monitoring filters
102
Advertisement
Table of Contents
