Sleep Mode; Deep Sleep Mode - Teltonika FM6320 User Manual

Event on Zone Entrance: record is generated when actual source value input is between
High and Low level ranges which are set in configuration;
Event on Zone Exit: record is generated when actual source value input increases and
becomes higher than High level and Low level values;
Event on Both: record is generated when actual source value input increases/decreases and
becomes higher/lower than high and low level declared values;
Monitoring: no event at all; I/O values are recorded only when other trigger have worked
(GPS acquisition or other I/O trigger)
Hysteresis: record is generated when actual source value input becomes higher than High
level value, and decreasing becomes less than Low level value
Event on Change: record is generated on every source value change.
9

SLEEP MODE

While in sleep mode, FM6320 sets GPS receiver to sleep mode but GSM/GPRS module
stays active, in Sleep mode power usage can be decreased to save vehicle's battery, because GPS
module is turned off.
FM6320 can enter sleep mode if ALL of these conditions are met:
 FM6320 has to be configured to work in Sleep mode;
 Start-up timeout has elapsed (5 minutes after every restart of the device);
 No movement by accelerometer is detected;
 Ignition is off;
 USB cable is not connected.
FM6320 exits sleep mode if ONE of the following conditions are true:
 Movement by accelerometer is detected (depends on accelerometer start settings);
 Ignition (DIN1) is turned on (driven logic high);
 USB cable is connected;
 HIGH or PANIC priority eventual record is detected;
While being in sleep mode FM6320:
 cannot save periodical or eventual records;
 send data to server;
10

DEEP SLEEP MODE

While in deep sleep mode, FM6320 sets GPS receiver to sleep mode and turns off
GSM/GPRS module (it is not possible to wake up device via SMS), therefore records with last
good coordinates are being saved and sent to AVL server if configured (GSM/GPRS module is
turned on to send data and after turned off). Depending on two configurable parameters, send
period and min period, in Deep Sleep mode power usage can be decreased to save vehicle's
battery.
76