Ibutton List - Teltonika FM6320 User Manual

Auto Geofencing option can be configured by following parameters (Figure 34):
 Activation TMO – Time period before Geofence is activated after vehicle stops.
 Deactivate By:
 Ignition – if ignition becomes high it will drop AutoGeofenze Zone
 iButton – if iButton is attached it will drop AutoGeofence Zone
 Edit iButton List – if list is not empty, attached iButton is tested against iButton list, if
match is found AutoGeofence zone is dropped.
 Priority – Priority of generated event, which will be applied to saved record.
 Generate Event:
 Enter Event – Event generation on Geofence entrance.
 Exit Event – Event generation on Geofence exit.
 On Both - Event generation on Geofence entrance or exit.
 No Event
Auto Geofencing does not require entering coordinates, instead it requires GPS visibility. If
vehicle stopped and activation timeout is reached, Auto Geofence will be created around the
vehicles last position by set Radius value. Auto Geofence event generation works the same as
Geofencing mentioned above.

6.3.3.3.5 iButton List

iButton list is used to enter authorized iButton ID codes, which are used to authenticate
driver in Authorized driving and Auto Geofencing options.
Figure 34 FM6320 Features->Geofencing Configuration (2)
44