Table of Contents
Advertisement
Command
#SET REPRTX=Y
#GET REPDISTX
#SET REPDISTX=Y
#GET REPANGX
#SET REPANGX=Y
#GET SENDPERIODX
#SET SENDPERIODX=Y
#GET REPMRX
#SET REPMRX=Y
#GET IBTNX=Y
#SET IBTNX=Y,Z
#GET EXTERR
#SET EXTERR=X
There is also a possibility to send the same messages as in SMS command list (chapter 11).
The device sends a response to every command received.
Command
Description
getstatus
Modem Status information
getweektime
Current device time, Day of Week and amount of minutes passed since start of
week
getops
List of currently used and available GSM operators
readops#
Emergency gsm operator readout from active profile
# - 1,2,3
1 – operators [1-20]
2 – operators [21-40]
3 – operators [41-50]
getnmeainfo
Nmea error debug sms
getcfgtime
Date and Time of last successful configuration
getgps
Current GPS data and time
loadprofile#
Load specified profile into RAM Engine Profile. # - number of profile to load
cpureset
Reset CPU
resetallprof
Reset all FLASH profiles to default profile
getver
Device / Modem / Code version information
getinfo
Device runtime system information
deleterecords
Delete all records saved on FLASH
getio
Readout digital inputs and outputs, analog inputs
Description
Set MinPeriod to the configuration of a certain profile, X – profile, Y –
MinPeriod value
Get MinDistance from the configuration of a certain profile, X – profile
Set MinDistance to the configuration of a certain profile, X – profile, Y –
MinDistance value
Get MinAngle from the configuration of a certain profile, X – profile
Set MinAngle to the configuration of a certain profile, X – profile, Y –
MinAngle value
Get SendPeriod from the configuration of a certain profile, X – profile
Set SendPeriod to the configuration of a certain profile, X – profile, Y –
SendPeriod value
Get MinRecords from the configuration of a certain profile, X – profile
Set MinRecords to the configuration of a certain profile, X – profile, Y –
MinRecords value
Get iButton value from the configuration of a certain profile, X – profile, Y
– number on the list
Set iButton value to the configuration of a certain profile, X – profile, Y –
number on the list, Z – iButton value
Get extended errors value
Set extended errors value, X – 0/1
131
Advertisement
Table of Contents
