Table of Contents
Advertisement
Estimated Time of Arrival Protocol:
• Dispatcher/office can request the ETA of the current stop/job in progress.
• Garmin will notify the actual time of arrival as well as distance remaining to stop.
Auto-Arrival at Stop Protocol:
• This feature is used to tell the Garmin PND to automatically detect that it has arrived at a
Stop and then to prompt the driver if they would like to mark the
Stop as done and begin navigating to next Stop on the list.
• Auto-arrival can be determined by how long the unit is stopped close to the destination
(in the event driver has to park and walk) or by how close the unit needs to be to the destination
before the Auto-arrival feature is activated.
Data Deletion Protocol:
•
Dispatch/office has the ability to wipe clean the data on the Garmin PND.
• Clean up messages in inbox/remove stops.
16.1.2 Enhanced protocols
Canned Responses/Messages:
• Fleet managers can communicate by sending up to 200 "canned" responses from server
to be stored directly on Garmin devices.
• Up to 50 of these canned responses can be utilized for any given scenarios.
• Drivers can store up to 120 canned messages, eliminating the need to type while driving.
Status Protocol:
•
Up-to-the-minute communications that allow drivers to automatically send status
updates.
• Driver's units can store up to sixteen status indicators such as start/stop shift, on/off
break, etc.
16.2 Supported features on Tavl client application
Tavl client application lets user to use the following features of GARMIN FMI:
1. Text messaging.
2. Destination message.
3. ETA request.
16.3 Text messaging
Text messaging feature lets user to communicate with driver (user that uses Garmin
device) by sending text messages via GPRS.
16.4 Destination message
Destination message is used to inform a driver of a new destination. When Garmin device
receives a destination message from server it displays it as "Stop" to the driver and also gives the
driver ability to start navigating to the "Stop" location. New destination in Tavl client is
represented as Geozone so new Geozone (as destination) has to be created first.
126
Advertisement
Table of Contents
