Overspeeding Scenario; Mounting Requirements And Working Conditions; Configuration; Immobilizer/ Authorized Driving Scenario - Teltonika FM6320 User Manual

generated. Record is saved and sent to server (FM6320 must be configured properly).
Event value is multiplied by 10 before sending/saving record to get more precision
when displaying data*.
Digital output No.1 is activated for a period of time to warn driver. Output on-time
should/can be configured separately for each case.
*Example. If acceleration harsh event of 3.55 m/s2 detected. Record with value 3.55*10 = 35.5
≈ 36 will be saved ant sent to server.

11.2 Overspeeding Scenario

Overspeeding. Helps to prevent from exceeding fixed speed and inspects driver if needed.
Any DOUT (which is configured) is controlled by scenario for user needs, to manage buzzer, LED
etc.

11.2.1 Mounting Requirements and Working Conditions

1. All scenarios on corresponding Digital Output can be enabled at once.
2. Ignition must be on.
3. Device module mounting position doesn't have any influence for correct scenario
operation.

11.2.2 Configuration

Overspeeding. Selects which DOUT will control Overspeeding scenario.
Max Allowed Speed. Set speed limit to reach without triggering Overspeeding event.

11.3 Immobilizer/ Authorized Driving Scenario

Immobilizer (iButton list checking disabled). Vehicle can be used only if iButton is
connected. In this scenario iButton list is not used; connect any iButton to pass Immobilizer
security. Selected DOUT is controlled by scenario for user needs.
11.3.1 Configuration
Figure 56 Overspeeding configuration parameters
82