Ep Setup - Lexmark MX71x Service Manual

Each time the value is increased by one, the strobe is sampled 50 nanoseconds longer. Each time the value is decreased
by one, the strobe is sampled 50 nanoseconds less than the default value. The range of values is between -4 and +6, in
increments of one. A value of zero indicates no change is made from the factory setting.
To change this setting:
From the Diagnostics menu, navigate to PRINTER SETUP > Par 1 Strobe Adj.

EP SETUP

EP Defaults
This setting restores each printer setting listed in EP SETUP to its factory default value. Sometimes this is used to help
correct print quality problems.
To restore the EP defaults:
1
From the Diagnostics menu, navigate to:
EP Setup > EP Defaults
2
Select Restore to restore the default values, or press X to exit without changing the settings.
Fuser Temperature (Fuser Temp)
This setting adjusts the fuser temperature to solve problems with paper curl on low‑grade paper and/or melting of
letterheads on some papers.
To adjust this setting:
1
From the Diagnostics menu, navigate to:
EP Setup > Fuser Temp
2
Press OK or touch
Fuser Page Count
The value of this setting indicates the total number of pages that have been printed by the fuser in the space below
the header.
To view the fuser page count:
From the Diagnostics menu, navigate to EP Setup > Fuser Page Count.
Note: The value of the setting cannot be changed manually.
Warm Up Time
This setting controls the amount of time the printer warms up before allowing pages to print. The range of values is
between 0 and 5, where 0 is no warm‑up time and 5 is up to 90 seconds of warm‑up time.
To change this setting:
From the Diagnostics menu, navigate to EP Setup > Warm Up Time.
to save any changes.
Service menus
351
7463