O: Operator-Related Settings; O: Operator-Related Settings; O1: Hoa Keypad Display Selection; O2: Hoa Keypad Functions - YASKAWA Z1000 Technical Manual

B.11 o: Operator-Related Settings
B.11 o: Operator-Related Settings
The o parameters set up the digital operator displays.
u

o1: HOA Keypad Display Selection

No.
(Addr. Name
Hex)
HOA Keypad Operator
o1-03
Display Selection
(502)
Display Unit Sel
Frequency Reference
o1-09
Display Units
(51C)
Fref Disp Unit
User-Set Display Units
o1-10
Maximum Value
(520)
UserDisp Scaling
User-Set Display Units
o1-11
Decimal Display
(521)
UserDisp Dec Sel
<1> Default setting is dependent on parameter o1-03, HOA Keypad Display Selection.
u

o2: HOA Keypad Functions

No.
(Addr. Name
Hex)
o2-04 Drive Model Selection
(508) Inverter Model #
332
Sets the units the drive should use to display the frequency reference and motor
speed monitors.
0: 0.01 Hz
0: 0.01 Hz
1: 0.01% (100% = E1-04)
1: 0.01%
2: r/min (calculated using the number of motor poles setting in E2-04,
2: r/min
E4-04, or E5-04)
3: User-selected units
3: User Units
Sets unit display for the frequency reference parameters and frequency related
monitors when o1-03 > 40.
0: "WC (Inch of water)
0: "WC
1: PSI (Pounds per square inch)
1: PSI
2: GPM (Gallons per minute)
2: GPM
3: F (Degrees Fahrenheit)
3: °F
4: CFM (Cubic feet per minute)
4: CFM
5: CMH (Cubic meters per hour)
5: CMH
6: LPH (Liters per hour)
6: LPH
7: LPS (Liters per second)
7: LPS
8: Bar (Bar)
8: Bar
9: Pa (Pascal)
9: Pa
10: C (Degrees Celsius)
10: °C
11: Mtr (Meters)
11: Mtr
12: Ft (Feet)
12: Ft
13: LPM (Liters per minute)
13: LPM
14: CMM (Cubic meters per minute)
14: CMM
16: None
16: No Unit
These settings define the display values when o1-03 is set to 3.
o1-10 sets the display value that is equal to the maximum output frequency.
o1-11 sets the position of the decimal position.
0: No decimal point
0: No Dec (XXXXX)
1: One decimal point
1: 1 Dec (XXXX.X)
2: Two decimal points
2: 2 Dec (XXX.XX)
3: Three decimal points
3: 3 Dec (XX.XXX)
Enter the drive model. Setting required only if installing a new control board. Default:
YASKAWA ELECTRIC SIEP YAIZ1B 01E YASKAWA AC Drive – Z1000 Bypass Technical Manual
Description
(set by o1-10 and o1-11)
Description
Values Page
Default: 0
183
Range: 0 to 3
Default: 16
183
Range: 0 to 14; 16
<1>
Default:
184
Range: 1 to 60000
<1>
Default:
184
Range: 0 to 3
Values Page
Determined by 184
drive capacity