Apogee Fln Set-Up; Apogee Fln Set-Up; Z1000 Bypass Parameter Settings For Apogee Fln Communications - YASKAWA Z1000 Technical Manual

E.1 APOGEE FLN Set-Up
E.1 APOGEE FLN Set-Up
A Yaskawa America representative is responsible for proper configuration of the Bypass for its primary application, while a
Siemens Building Technologies representative is responsible for field panel programming to make use of the Bypass
functionality in the building automation system. As such, there must be coordination between the Yaskawa America and
Siemens Building Technologies representatives to ensure that the programming of the drive is consistent with the particular
application requirements. After verifying that the drive installation and wiring are correct, apply power to the drive.
Drive Communication Parameter Settings on page 408
communication and control.
u

Z1000 Bypass Parameter Settings for APOGEE FLN Communications

Parameter Number
Z1-07
Z1-08
Z3-02
Z3-03
Z3-01
NOTICE: A Yaskawa representative should set the drive parameters to their appropriate values. Changes made to the parameters other
than what is listed in the table above can result in damaging the drive or building equipment.
408
lists parameters and values required for proper APOGEE FLN
Table E.1 Drive Communication Parameter Settings
Digital Operator Display
Reference Source
Run Source
Serial Comm Adr
Serial Baud Rate
Protocol Select
YASKAWA ELECTRIC SIEP YAIZ1B 01E YASKAWA AC Drive – Z1000 Bypass Technical Manual
Settings for APOGEE FLN Communication
2: Serial Com
2: Serial Com
Select the Bypass address
2: 4800 Baud
2: P1
Refer to