5.2.1 Fast Configuration - Comtec CDM-840 Installation And Operation Manual

CDM-840 Remote Router
FAST Activation Procedure

5.2.1 FAST Configuration

The read-only table in this section displays the CDM-840 available FAST Features and the
operational status for each option:
Column Description
Option This column lists each available FAST Feature.
Status This column identifies each FAST Feature operational parameter(s). If an option is not enabled,
the column displays this information.
The complete roster of FAST Accessible Options is as follows:
Option
CCM (VersaFEC only)
CCM (DVB-S2 only)
E1 Interface
G.703 Clock Extension
dSCPC (Dynamic Single Carrier per Channel)
1) Tx Header and Payload Compression and Quality of Service (QoS)/Advanced QoS
are standard (non-FAST) operational features for Comtech EF Data's Advanced
VSAT Series group of products. If these features are listed in the FAST
Configuration table, they are always indicated as Enabled.
2) E1 Interface operation is not available with the ODMR-840 Reduced Form Factor
Outdoor Remote Router.
16 kbps – 256 kbps Tx Data/Symbol Rate
16 kbps – 512 kbps Tx Data/Symbol Rate
16 kbps – 1024 kbps Tx Data/Symbol Rate
16 kbps – 2.048 Mbps Tx Data/Symbol Rate
16 kbps – 5 Mbps Tx Data/Symbol Rate
16 kbps – 10 Mbps Tx Data/Symbol Rate
16 kbps – 15.35 Mbps Tx Data/Symbol Rate
1 – 15 Mbps Rx Data/Symbol Rate
1 – 45 Mbps Rx Data/Symbol Rate
1 – 100 Mbps Rx Data/Symbol Rate
Full Support E1 (hardware upgrade also required)
5–3
MN-CDM840
Revision 3