Versafec Acm; Cdm-840 Versafec Acm Operation; Versafec Acm Operation Using The Http Interfaces - Comtec CDM-840 Installation And Operation Manual

CDM-840 Remote Router
Appendix D
D.3

CDM-840 VersaFEC ACM Operation

The CDM-840 provides several means for configuring VersaFEC ACM operation via Remote
Product Control with a user-supplied PC:
•
CDM-840 HTTP (Web Server) Interface using a compatible Web browser.
•
Ethernet-based Simple Network Management Protocol (SNMP) using a Network
Management System (NMS) and Management Information Base (MIB) File Browser.
COMTECH EF DATA RECOMMENDS USE OF THE SERIAL-BASED REMOTE CONTROL
INTERFACE AND THE ETHERNET-BASED SNMP INTERFACE ONLY FOR ADVANCED
USERS. COMTECH EF DATA STRONGLY ENCOURAGES USE OF THE CDM-840 HTTP
INTERFACE FOR MONITOR AND CONTROL (M&C) OF THE CDM-840.
THE HTTP INTERFACE FIGURES AS FEATURED THROUGHOUT THIS APPENDIX ARE
INTENDED FOR USER REFERENCE ONLY AND ARE SUBJECT TO CHANGE. THE
FIRMWARE INFORMATION (I.E., REVISION LETTERS, VERSION NUMBERS, ETC.) AS
DISPLAYED MAY DIFFER FROM YOUR SETUP.
D.3.1

VersaFEC ACM Operation Using the HTTP Interfaces

YOU MAY PROCEED WITH ETHERNET-BASED REMOTE PRODUCT MANAGEMENT
(HTTP OR SNMP), ASSUMING THAT:
•
YOUR CDM-840 IS OPERATING WITH THE LATEST VERSION FIRMWARE FILES.
•
YOUR CDM-840 IS CONNECTED TO A USER-SUPPLIED, WINDOWS-BASED PC AS
FOLLOWS:
O THE PC SERIAL PORT IS CONNECTED TO THE CDM-840 REAR PANEL
O THE PC ETHERNET PORT IS CONNECTED TO THE CDM-840 REAR PANEL
O THE PC IS RUNNING A TERMINAL EMULATION PROGRAM (FOR OPERATION
•
YOU HAVE NOTED THE CDM-840 MANAGEMENT IP ADDRESS USING THE
CDM-840 SERIAL INTERFACE.
'CONSOLE' PORT WITH A USER-SUPPLIED SERIAL CABLE.
'ETHERNET | MANAGEMENT | FE' ETHERNET PORT WITH A USER-SUPPLIED
HUB, SWITCH, OR DIRECT ETHERNET CABLE CONNECTION.
OF THE CDM-840 SERIAL INTERFACE) AND A COMPATIBLE WEB BROWSER
(FOR OPERATION OF THE HTTP INTERFACE).
D–5
MN-CDM840
Revision 3