Configuration | Network | Arp - Comtec CDM-840 Installation And Operation Manual

CDM-840 Remote Router
Ethernet-based Remote Product Management
6.3.3.3.2

Configuration | Network | ARP

Use this page to configure the CDM-840 ARP (Address Resolution Protocol) parameters.
Add Static ARP
Enter the desired IP and MAC addresses. Click [Add Entry] when done. The Index column
automatically increments to the next available number when the specified static ARP entry is
added to the ARP Table.
Comtech EF Data recommends that you do not add Static ARP entries. Dynamic
ARPs should function as expected under normal operation. You should use Static
ARP entries only when it has been demonstrated that a connected networking
device does not respond to ARP as expected.
Delete Static ARP
Enter the Entry Index to Delete. Click [Delete Entry] to delete the specified entry index from the
ARP Table. Upon deletion, the ARP Table index number automatically decrements to the next
available number.
Flush Dynamic ARP
Click [Flush Dynamic ARP] to delete all dynamically-learned ARP entries.
ARP Table (Edit)
This section displays all current Static and Dynamic ARP entries, and allows to user to directly
edit the current Static ARP entries. From left to right:
Figure 6-29. Configuration | ARP Page
6–58
MN-CDM840
Revision 3