Comtec CDM-840 Installation And Operation Manual page 195

CDM-840 Remote Router
Serial-based Remote Product Management
Command Number of
Parameter (Instruction Arguments for
Type Code Command or
& Qualifier) Response to Query
Management N/A 12 bytes,
MAC Address alphanumeric
GE MAC N/A 12 bytes,
Address alphanumeric
Management MLC= 1 byte
Link
Configuration
Actual N/A None
Negotiated
Port Speed
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 and 57)
Query only.
Returns the unique FE management port MAC Address in the form
xx:xx:xx:xx:xx:xx
EXAMPLE: <0/MAC?[cr]
>0000/MAC=00:06:B0:00:01:C2[cr][lf]
Query only.
Returns the unique GE traffic port MAC Address in the form xx:xx:xx:xx:xx:xx
EXAMPLE: <0/MG1?[cr]
>0000/MG1=00:06:B0:00:01:C2[cr][lf]
Command or Query.
Sets or returns 10/100 BaseT Fast Ethernet FE Management port Interface
Mode in the form x, where:
0=Auto Negotiate
1=reserved
2=100 Mbps Full Duplex
3=100 Mbps Half Duplex
4=10 Mbps Full Duplex
5=10 Mbps – Half Duplex
EXAMPLE: <0/MLC=3[cr]
Query only.
Returns actual negotiated port speed in the form ab, where:
a=GE traffic port negotiated port speed.
b=FE management port negotiated port speed.
'a' and 'b' have the following values:
0=Link down
1=100 Full Duplex
2=100 Half Duplex
3=10 Full Duplex
4=10 Half Duplex
5=1000 Full Duplex
EXAMPLE: <0/NPS?[cr]
>0000/NPS=2[cr][lf]
7–27
Response to Query
Command (Instruction Response to Query
(Target to Code & (Target to Controller)
Controller) Qualifier)
N/A MAC? MAC=xx:xx:xx:xx:xx:xx
(see Description of
Arguments)
N/A MG1? MG1= xx:xx:xx:xx:xx:xx
(see Description of
Arguments)
MLC = MLC? MLC =x
MLC? (see Description of
MLC * Arguments)
MLC #
N/A NPS? NPS=ab
(see Description of
Arguments)
MN-CDM840
Revision 3