Transmit (Tx) Bert Command Or Query; Receive (Rx) Bert Command Or Query; Buc (Block Up Converter) Parameters Commands And Queries - Comtec CDM-840 Installation And Operation Manual

CDM-840 Remote Router
Serial-based Remote Product Management
7.3.5

Transmit (Tx) BERT Command or Query

Command Number of
Parameter (Instruction Arguments for
Type Code Command or
& Qualifier) Response to Query
Tx BERT BTX= 1 byte
State
7.3.6

Receive (Rx) BERT Command or Query

Command Number of
Parameter (Instruction Arguments for
Type Code Command or
& Qualifier) Response to Query
Rx BERT BRX= 1 byte
State
7.3.7

BUC (Block Up Converter) Parameters Commands and Queries

Command Number of
Parameter (Instruction Arguments for
Type Code Command or
& Qualifier) Response to Query
BUC ATT= 4 bytes
Attenuation
BUC FSK BAD= 2 bytes
Address
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 and 57)
Command or Query.
Sets or returns Tx BERT State in the form x, where:
0=Off
1=On
EXAMPLE: <0/BTX=1[cr]
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 and 57)
Command or Query
Sets or returns Rx BERT state in the form x, where:
0=Off
1=On
EXAMPLE: <0/BRX=1[cr]
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 and 57)
Command or Query.
Sets or returns BUC attenuation level in the form xxxx, where:
xxxx=value from -1 to 3000 (in 1/100 dB), in 0.25 dB increments
EXAMPLE: <0/ATT=2[cr]
Command or Query.
NOTE: FOR USE ONLY WITH BUCS THAT SUPPORT FSK.
Sets or returns BUC Address in the form xx, where:
xx=value from 01 to 15
EXAMPLE: <0/BAD=1[cr]
7–17
Response to Query
Command (Instruction Response to Query
(Target to Code & (Target to Controller)
Controller) Qualifier)
BTX= BTX? BTX=x
BTX? (see Description of
BTX# Arguments)
Response to Query
Command (Instruction Response to Query
(Target to Code & (Target to Controller)
Controller) Qualifier)
BRX = BRX? BRX=x
BRX? (see Description
BRX * of Arguments)
BRX #
Response to Query
Command (Instruction Response to Query
(Target to Code & (Target to Controller)
Controller) Qualifier)
ATT= ATT? ATT=xxxx
ATT? (see Description of
ATT* Arguments)
ATT#
BAD= BAD? BAD=xx
BAD? (see Description of
BAD* Arguments)
BAD#
MN-CDM840
Revision 3