Miscellaneous Utility Commands And Queries - Comtec CDM-840 Installation And Operation Manual

CDM-840 Remote Router
Serial-based Remote Product Management
7.3.14

Miscellaneous Utility Commands and Queries

Command Number of
Parameter (Instruction Arguments for
Type Code Command or
& Qualifier) Response to Query
Change CWM= 1 byte
Working
Mode
Reset DPC DPD= None
power to
factory
default
Force Reboot FRB= N/A
Ping Host PING[sp] 16 bytes
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 and 57)
Command or Query.
Sets or returns Working Mode in the form x, where:
0=Router Mode
1=BPM (Bridge Point to Multipoint) Mode
EXAMPLE: <0/CWM=0[cr] (Sets Working Mode to Router Mode)
Command only.
NOTE: THIS COMMAND TAKES NO ARGUMENTS.
Resets Dynamic Power Control and the Entry Channel Mode Tx Base Power
value to the factory default.
CAUTION – YOU SHOULD QUERY THE ENTRY CHANNEL MODE TX
BASE POWER SETTING (<0/EBP=?[cr]) BEFORE USING THIS
COMMAND. YOU MAY RESTORE THE ENTRY CHANNEL MODE TX BASE
POWER VALUE WITH THE 'EBP' COMMAND.
EXAMPLE: <0/DPD[cr]
Command only.
NOTE: THIS COMMAND TAKES NO ARGUMENTS.
Forces the system to reboot.
CAUTION – TAKE CARE WHEN USING THIS COMMAND. THE SYSTEM
WILL REQUEST NO CONFIRMATION AND WILL NOT WARN YOU
BEFORE SYSTEM REBOOT OCCURS.
EXAMPLE: <0/FRB[cr]
Command only.
Execute PING to send four 64-byte ICMP echo request packets to the host. A
valid connection triggers an ICMP response. The host IP Address is in the
form xxx.xxx.xxx.xxx.
EXAMPLE: <0/PING[sp]xxx.xxx.xxx.xxx[cr]
7–33
Response to Query
Command (Instruction Response to Query
(Target to Code & (Target to Controller)
Controller) Qualifier)
CWM = CWM ? CWM=x
CWM? (see Description
CWM * of Arguments)
CWM #
DPD= N/A N/A
DPD *
FRB= N/A N/A
FRB*
PING = N/A N/A
MN-CDM840
Revision 3